Step by Step Guide on How to Change the Belt in a Bissell Vacuum

To change the belt in a Bissell vacuum, start by turning off and unplugging the machine. This is a crucial safety step to avoid any accidental start-ups.

The belt is usually located at the back or bottom of the vacuum, and it's a good idea to consult your user manual for specific instructions. In most Bissell vacuums, the belt is held in place by a small clip or screw.

You'll need to remove the dust bag or container to access the belt. In some models, you'll also need to remove a small panel or plate to get to the belt.

Once you've located the belt, take a moment to inspect it for any signs of wear or damage. If the belt is damaged, it's best to replace it with a new one to ensure optimal performance.

Check this out: Dyson Hand Vacuum Cleaners

To remove the old belt from your Bissell vacuum cleaner, you'll need to start by turning the vacuum over and removing the soleplate by taking off the four screws on the base.

This will give you access to the drive belt wrapped around the brushroll and motor spindle. Safety first, make sure you've disconnected the appliance from the mains before starting any repair.

You can then use your finger to remove the belt from the motor spindle, or a flathead screwdriver if it's extremely tight.

Once the belt is off the motor spindle, release the brush roll which in turn releases the belt.

Alternatively, you can access the belt by removing the soleplate and then accessing the brush carriage by pulling it towards you until it stops.

Suggestion: Access Tool Belt Runescape

Before you start preparing for the new belt, make sure you have a replacement belt that matches your Bissell vacuum's specifications.

The new belt should be compatible with your vacuum's model and have the correct size and type. For example, the belt on your Bissell vacuum might be a 5/8" wide rubber belt.

Take a few minutes to locate the old belt and remove it from the vacuum. This will give you a good idea of how it's installed and what you need to do to replace it.

Explore further: How to Clean Bissell Vacuum Filter

The old belt is usually attached to the vacuum's motor and the brush roll. You'll need to release the tension on the belt before you can remove it.

Remove any screws or clips that hold the belt in place, and gently pull the belt off the motor and brush roll.

You might enjoy: Vacuum with Self Cleaning Brush

Installing a new belt in your Bissell vacuum is a relatively straightforward process. You'll find the instructions for this on a white label on the lower back or bottom of the machine, or behind the cleaning tanks.

To start, place the new belt over the small pulley first, then slip it over the large pulley. This ensures the belt is properly seated and ready for the next steps.

Next, replace the brush carriage and screws, and push the brush carriage back into place, making sure the latch locks securely.

Here's a quick rundown of the key steps:

By following these simple steps, you'll have your new belt installed and your vacuum up and running in no time.